Skip to main content
English

Home›Guides›Wheels and spacers›Wheel spacers

Wheels and spacers

Wheel spacers

A wheel spacer is fitted between the hub and the wheel and moves the wheel outwards. It lines the wheel up with the wing without changing wheels, or makes room for a large brake caliper. We offer Powertech spacers for most cars.

Powertech systems

  • Bolt-on (A1, A2): the spacer is bolted to the hub with its own bolts (A1) or pressed-in studs (A2). The wheel is then mounted on the spacer with the original bolts or nuts.
  • Through-bolt (DZX, DZX1, AZX, DAX): the wheel bolts pass through the spacer. Longer bolts or studs are needed, sold separately. Centring rings adapt the spacer to the hub.
  • Other systems (D1, D2, D3, DZ): standard Powertech systems, depending on the vehicle.

What changes

  • Wider track: the wheel sits further out. Handling can become more stable, but the loads on wheel bearings and the front axle increase.
  • Offset (ET): a spacer reduces the effective ET of the wheel by its thickness in millimetres.

Making the right choice

  • Bolt length: the thread engagement must remain sufficient. A bolt that is too short is dangerous.
  • Centring: the spacer must centre the wheel on the hub, with the specified ring if needed.
  • Bodywork: the wheel must stay covered by the wing and must not rub on full lock or under compression.
  • With aftermarket wheels: check the total offset of wheel plus spacer. See Wheels.

Road approval in Switzerland

  • A spacer up to 5 mm can be exempt from inspection if the widening stays very small (no more than 1% of the track width per wheel).
  • Beyond that, the modification must be reported and inspected, with a report from a recognised body such as DTC or FAKT. Such reports exist for Powertech spacers for most vehicles.
  • Send us a copy of your vehicle registration document with personal data hidden: we check the spacer, the bolts and the documents before you order.

See our spacers